top of page
Search

Multilayer Oak Flooring — Real Wood, Built to Stay Flat

Writer: Red Dot Real Estate Development
Red Dot Real Estate Development
Oct 30
2 min read

Multilayer oak laid in one of the bedrooms.


The wooden floors are going down at Azuaga 68 and Ernesto 65. Bedrooms and living rooms receive NOXUS multilayer oak flooring, supplied by the Portuguese company A.Barbosa: genuine oak on the surface you see and touch, with an engineered body underneath that keeps every board flat and stable.


What "multilayer" means. Each board is 14 mm thick and built from layers bonded together with their grain running in opposite directions. On top, a 3 mm layer of solid oak — the surface you walk on. Beneath it, a poplar core and a 1 mm wood backing. Crossing the layers is what makes the difference: each one holds the others in place.



The label says it all: multilayer wood, 14 mm thick, with a 3 mm natural oak top layer.



Why not solid wood? Solid boards swell and shrink with every change in humidity and season, which is how traditional floors end up with gaps, cupped boards and creaks. A multilayer board keeps the look and the warmth of solid oak, with far greater dimensional stability.

Real oak, renewable. Unlike laminate or vinyl, which carry a printed image of wood, the top layer here is real oak, factory-finished with a matt Bona varnish. With 3 mm of solid wood, the floor can be sanded and refinished years from now and look new again.



Boards waiting to be laid — the layered build of each one is visible along its edge.


Wide, long planks. Each board measures 19 cm wide by 1.90 m long. Fewer joints, a calmer floor and the generous proportions of a classic plank floor.

Glued, not floating. These boards could simply be clicked together and laid loose, as a floating floor. We chose to go further: every board is fully bonded to the screed with flooring adhesive, spread with a notched trowel across the whole surface. The floor feels solid underfoot, without the hollow, "drum-like" sound of floating floors, and it will not move or creak over the years.



Laying the boards in one of the living rooms.


The adhesive spread over the screed, just ahead of the next row of boards.


Approved before a single board was laid. The contractor submitted the flooring's technical data sheet to the site supervision, and only after approval did the material reach the site.

What lies beneath: quiet between neighbours. The wood is only the last layer of a floor build-up 43.5 cm thick between apartments. From the bottom up: plasterboard ceiling with 5 cm of mineral wool, a 22 cm reinforced concrete slab, 7 cm of lightweight expanded-clay screed, an impact-sound insulation layer, a 5 cm screed and, finally, the wood floor. The impact-sound insulation also runs up the walls as a perimeter strip, so the screed never touches the structure — footsteps stay in the apartment where they are made. In the apartments above the garage, 8 cm of thermal insulation sit under the screed instead, keeping the floor warm.

The result: the warmth of real oak underfoot, a floor that stays flat, and the quiet that only a well-built floor can give.

 
 
 

Comments


bottom of page